[Rsiena-help] [rsiena-help][5137] problem in running my model

[Ruth M. Ripley]

Dear Jia,

The message indicates that the simulation process cannot terminate. This 
could be because the rate parameter has been made so large the steps 
happen too frequently or because the network cannot make any more changes.

If you cannot work out what has happened, give me a bit more information: 
are you using the siena01Gui, or the command line interface, which version 
of RSiena, R,... Then I can tailor my advice as to the next step.

Regards

Ruth


On Thu, 3 Nov 2011, Forum wrote:

>
> Read and respond to this message at:
> https://r-forge.r-project.org/forum/message.php?msg_id=5137
> Or by replying to this e-mail entering your response between the following markers:
> #+#+#+#+#+#+#+#+#+#+#+#+#+#+#+#+#+
> (enter your response here)
> #+#+#+#+#+#+#+#+#+#+#+#+#+#+#+#+#+
>
>
> By: Jia  Lu
>
> After I try to run my preliminary model in RSiena, it always gives me an error
> message saying:
>
>
> Error in x$FRAN(zsmall, xsmall) :
>
>  Unlikely to terminate this epoch:  more than 1000000 steps
>
>
>
> Is it because something I did with model specification or my computer?
>
>
>
> A million thanks!
>
>
>
> Jia
>
> ______________________________________________________________________
> You are receiving this email because you elected to monitor this forum.
> To stop monitoring this forum, login to R-Forge and visit:
> https://r-forge.r-project.org/forum/monitor.php?forum_id=1525&group_id=461&stop=1
>